|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-27-2013, 10:43 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,553
|
Re: Help! My A's engine is "stuck"
When the flywheel was installed it is possible that the dowell retainer (metal plate with 4 holes for flywheel bolts)could have been left off, this could cause the flywheel bolts to bottom out on the rear main part of the block locking the engine
Was work done inside the engine? ---if so perhaps the bearings are too tight |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:40 PM.