The Ford Barn

Gasoline · 08-07-2013, 05:03 AM

Hello again!

Which is the best ignition coil for a Mallory 27 series (dual points)? I´m already using a MSD Blaster 2 with external ballast resistor, but I´m gonna buy an extra ignition coil/ballast resistor and keep it in the toolbag.

I was tuning the carburetor (during idle) yesterday and I noticed that my MSD Coil was getting quite hot (140 fahrenheit) and so did the condenser. Is that ok? The coil is placed in front of the engine, to the right side of the distributor.

08-07-2013, 05:03 AM	#11
Gasoline Junior Member Join Date: Jul 2013 Posts: 17	Re: Mallory tech answer to coil/ballast ? Hello again! Which is the best ignition coil for a Mallory 27 series (dual points)? I´m already using a MSD Blaster 2 with external ballast resistor, but I´m gonna buy an extra ignition coil/ballast resistor and keep it in the toolbag. I was tuning the carburetor (during idle) yesterday and I noticed that my MSD Coil was getting quite hot (140 fahrenheit) and so did the condenser. Is that ok? The coil is placed in front of the engine, to the right side of the distributor.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode