|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
05-24-2025, 06:08 PM
|
#1 |
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 6,644
|
Re: New aluminum fan blade problem
It states in the first paragraph instructions from Snyder's to check for clearance and remove material from the water pump as needed. This is due to the aluminum fan/pulley being thicker than the sheet metal original shaft.
I have not had an issue with the taper. https://www.snydersantiqueauto.com/c...INUM%20FAN.pdf Last edited by Y-Blockhead; 05-24-2025 at 08:19 PM. |
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:02 AM.