03-28-2025, 06:21 PM
|
#1
|
|
Senior Member
Join Date: May 2010
Location: Sugar Land, TX
Posts: 4,420
|
Re: 40 flathead EFI
Quote:
Originally Posted by Thomas Sargent
EFI project completed. Engine started instantly on the first try. This is the autotrend unit from CA. Installed Manifold pressure sensor, ambient air temp sensor, coolant sensor, idle air control motor, , throttle position sensor was on throttle body, and one wire went to coil. installed O2 sensor in pas ex pipe, and a Holley HP processor under the seat, pass side. Put in the tank fuel pump and pressure reg in engine compartment. Lots more details, Attachment 563649
Attachment 563650
Attachment 563651
Attachment 563652 |
Cost?
|
|
|
Hybrid Mode
