|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-08-2021, 03:45 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 2,032
|
Re: Mitchell Overdrive problem
Del
I agree sounds like I’d make sure linkage is ok as suggested above , also, if rear engine mounts are bad or loose it could cause the engine and trans to move more then it should and cause the overdrive lever and linkage to disengage..... especially if linage isn’t fully engaged if out of adjustment. Larry Shepard |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:36 PM.