|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Junior Member
Join Date: Feb 2018
Location: Shelby NC
Posts: 23
|
![]()
On the 29 Model A I have a reoccurring problem. There is no fire at the points. Wires are clean, grounds are good, coil is hot, condenser is good. Yet last night it ran great, this morning no fire at the points. Yesterday I went through the distributor and all is fine. I pulled the distributor and ran it on a test engine and had the same problem. Took another distributor and put it in the car, same problem so I suspected the shielded cable. It is fine, and makes good contact, not shorting out. Then, it starts working again later on, no reason. I am running the distributor that has an acorn nut on the plate instead of the little wire that often gives trouble. All my points of contact are good. Replaced points, condenser all the guts. Same problem.
Any ideas? Thanks for the assistance! Mike Royster |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,964
|
![]()
The problem is probably the little acorn nut and brass strip that it rubs against not making good contact. You are better off with the fine-strand wire sold for this purpose.
![]()
__________________
Jim Cannon Former MAFCA Technical Director ![]() "Spread the Joy! Have a Model A day!" |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Junior Member
Join Date: Feb 2018
Location: Shelby NC
Posts: 23
|
![]()
Hi Jim, I have run these for years and no problems, and it is making really good contact. Other ideas?
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,964
|
![]()
Try a new condenser.
In fact, try 2 new condensers if the first new one does not fix it. ![]()
__________________
Jim Cannon Former MAFCA Technical Director ![]() "Spread the Joy! Have a Model A day!" |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Jun 2013
Location: Western Springs, IL
Posts: 324
|
![]()
Since the problem seems to be somewhat intermittent, it is in the movement of something electrical.. such as the acorn nut making/not making contact. wiring that is not quite securely fastened as it should be...
|
![]() |
![]() |
![]() |
#6 |
Junior Member
Join Date: Feb 2018
Location: Shelby NC
Posts: 23
|
![]() Sponsored Links (Register now to hide all advertisements)
Thanks to all that post their experiences and offer assistance! |
![]() |
![]() |
![]() |
#7 |
Junior Member
Join Date: May 2010
Location: Yelm Washington.
Posts: 8
|
![]()
I have the same issue. My quick fix is split a straw or tube and slip it over the cable wire. This stopped the short for now but I'll need the new cable.
Question is "which cable?". I'm seeing several types. What say you? |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|