|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-26-2020, 10:13 PM
|
#8 |
|
Senior Member
Join Date: May 2010
Location: Oshkosh, Wi
Posts: 4,600
|
Re: cylinder head studs
Set the head on and see which studs are offending. Run a nut on the stud and tap it over until it aligns. Go to next, etc. I would not enlarge the holes in the heads.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:24 AM.