Remote door handle spring install - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
Remote door handle spring install

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

03-19-2019, 09:01 PM	#2
51 MERC-CT Senior Member Join Date: May 2010 Location: East Hartford, Ct Posts: 5,898	Re: Remote door handle spring install Sponsored Links (Register now to hide all advertisements) I have done it without heating. Using a sharp chisel to start opening the tabs then a larger screw-driver like device to further open until able to grasp with vice grips to fully straighten. If any tabs break off a simple tack weld will secure the plate to the body. __________________ DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES Last edited by 51 MERC-CT; 03-19-2019 at 09:11 PM.

Sponsored Links (Register now to hide all advertisements)

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 06:05 PM.