|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-13-2018, 03:38 PM
|
#1 |
|
Senior Member
Join Date: Oct 2012
Location: Eastcoast
Posts: 883
|
Building a sleeve for a t170
I plan to build a sleeve for my T170 input shaft so I can use a and early through out bearing. A couple of questions.
1/ how tight should the ID be on the sleeve going over the transmission shaft? 2/ what is the best material to use? Thanks |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:44 PM.