|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
06-25-2016, 09:20 AM
|
#1 |
|
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 17,409
|
Re: Could Edelbrock cast a flathead block
The 221 blocks don't have a lot of meat in the cylinder walls. A person could sleeve a block out to go big bore but I doubt that it could take a bore job that large without sleeves. Folks don't usually bore them much more than 3 3/16".
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:26 PM.