|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
09-28-2014, 06:25 PM
|
#1 |
|
BANNED
Join Date: May 2012
Location: inside your RAM
Posts: 3,134
|
James Rogers, Brent, Purdy, etc...question
I am helping a friend with an engine which has too much clearance between timing gear and cam gear. A used DanM aluminum cam gear was on there, which seemed a bit beat up from being run loose on another motor, so I just now swapped it for a brand new DanM bronze gear.
__________________
'31 180A Last edited by tbirdtbird; 02-03-2017 at 10:35 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:02 AM.