Warping sheet metal - sandblasting - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
Warping sheet metal - sandblasting

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

02-27-2014, 08:03 AM	#26
wrndln Senior Member Join Date: May 2010 Location: Lakeville, MN Posts: 5,346	Re: Warping sheet metal - sandblasting Sponsored Links (Register now to hide all advertisements) Pooch, You must be superhuman to do 3 front fenders in an hour. I guess I don't have any skills doing sandblasting. It takes me much longer with my small tip, but I have never warped a piece or sheetmetal that I know of. I wish I could do a good job in 10 minutes a side, but it takes me much longer. I am retired, so my time isn't all that valuable. Rusty Nelson

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 05:32 AM.