The Ford Barn

Keith True · 06-22-2025, 08:01 AM

Sponsored Links (Register now to hide all advertisements)

Angle board first.You will be taking the flat board out ten times to one of the angle board.It sounds like the welting you are using might be too thick.Years ago I used felt stripping for house windows.It was a little thick,but it broke in to fit after a few years.Years ago I made some floors out of some real high quality plywood I had bought at an auction.It was a true 3/4 thick,maybe even 13/16.With welting I really needed closer to 11/16.I used it without welting in an A pickup in 04,now I've kind of forgot about it.I also used it for the floors in a Kenworth truck,but they're not too fussy.

06-22-2025, 08:01 AM	#4
Keith True Senior Member Join Date: May 2010 Location: Epping N.H. Posts: 3,424	Re: Floor boards-bottom or angle Sponsored Links (Register now to hide all advertisements) Angle board first.You will be taking the flat board out ten times to one of the angle board.It sounds like the welting you are using might be too thick.Years ago I used felt stripping for house windows.It was a little thick,but it broke in to fit after a few years.Years ago I made some floors out of some real high quality plywood I had bought at an auction.It was a true 3/4 thick,maybe even 13/16.With welting I really needed closer to 11/16.I used it without welting in an A pickup in 04,now I've kind of forgot about it.I also used it for the floors in a Kenworth truck,but they're not too fussy.