|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-07-2025, 12:22 PM
|
#27 |
|
Senior Member
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 5,881
|
Re: 1940 3/4-1 Ton express frame measurements
Do you have the large 'U' shaped radiator support and fender holder-upper? That ties everything together and mounts to the front crossmember with two large head carraige bolts and little else. There are springs like valve springs under the crossmember so the whole front clip has some 'give'. In this photo I show some temporary stay rods made from conduit so I could drive around without the front clip while I dialed in this transplanted six.
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1946 Tonner Pickup with 226 H six, 1979 Toyota landcruiser wagon, now wearing 1947 Ford Jailbar sheet metal. 'Rusty ol' floorboards, hot on their feet' (Alan Jackson) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:50 AM.