Chasing same issues again any ideas? ‘34

[34 fordor owner]

This is the starter that I’m working with and going to take off but before I do so I want to make sure I’m going to do it right. All I’m seeing that holds the starter on is the two bolts that use seen in the picture? Remove those two and it comes out?

I believe the cable is good but I will give it a thorough check to be sure. Also, I am getting 6.5volts all across now. Switch to input and output of resistor. Not going to attempt to start it again until I look at this starter and get the slow turn over fixed or better than 3 volts to the starter.