|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-05-2024, 01:48 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,972
|
Carburetor Fuel Level Gauge - Suggestions on making one please?
Our fuel level gauge has gone missing, and it appears they are out of stock, -so I guess I need to make one. Therefore I need a little inspiration.
If I were to use a regular carburetor drain, it appears I have around 3/16" of an area inside of the plug that could be drilled, ...then a small length of 3/16" O/D steel Brake line installed and JB Weld added to hold it in. It appears McMaster has 3/16" clear tubing. Before I go thru the steps of this, does anyone know of an easier way to make one of these?? |
|
|
)
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:03 PM.