|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-07-2023, 05:28 PM
|
#1 |
|
Junior Member
Join Date: Jan 2023
Location: North Idaho
Posts: 28
|
Tillotson carburetor question
While refreshing a Tillotson Carb and putting it back together I found that the upper pot metal piece is not flat. So when I am putting the 3 screws back together there is a gap large enough to where the gasket will not seal. Any suggestions on how to correct this? If it was the lower piece it looks like it would be easy to sand down flat.
Thanks in advance for any insight!! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:26 PM.