|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-02-2023, 11:21 AM
|
#1 |
|
Senior Member
Join Date: Jan 2020
Location: SF Bay Area
Posts: 2,110
|
Head stud pattern?
Does anyone have a dimensioned drawing of the head bolt pattern (X-Y)? I've broken a head stud and need to make up a jig to drill out the broken stud. I could make up a jig based upon the head or head gasket, but if I could find a properly dimensioned drawing it would be a lot easier. And likely more accurate.
I know there are commercial jigs out there but that takes time. And dollars for a special purpose tool I likely will never use again (I hope!). I have some stock I can repurpose. Thanks. JayJay
__________________
JayJay San Francisco Bay Area ------------------------ 1930 Murray Town Sedan 1931 Briggs S/W Town Sedan It isn't a defect, it's a feature! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:50 PM.