|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-03-2023, 03:20 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 9,083
|
A job on the lathe! Lightening a Flathead Flywheel.
In today's video I try my hand at lightening a flathead Ford flywheel. I didn't want to go too mad at it, but did take a few pounds off it. I also had a stab at balancing it using a method I have been developing. I think it came out ok, I hope you do too.
https://youtu.be/Ozcl47iublk |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:01 AM.