|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-19-2022, 01:32 PM
|
#1 |
|
Senior Member
Join Date: Sep 2020
Location: Mount Desert, Maine
Posts: 504
|
Temperature Indicator Part 68-10883 / Installation / Bulb Seals
I’ve just acquired a NOS indicator assembly which appears complete (and hopefully correct for a ‘36 Phaeton).
The reservoir bulb has a flange which needs, on its lower side, to seal to the face of the water pump receiving port and, on its upper face, to the underside of the sealing nut / bushing. Should any sealant be added to either surface of the bulb flange, or is it just a crush seal ? System is not pressurized. Thank you.
__________________
No job’s done ‘til it’s all done Last edited by Jacques1960; 07-19-2022 at 01:44 PM. Reason: Technical comment |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:17 AM.