|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-01-2022, 10:03 PM
|
#1 |
|
Junior Member
Join Date: Jul 2018
Location: langley bc canada
Posts: 25
|
Crab Distributor vacuum brake
When you install the crab distributor on the engine and screw in the vacuum brake, how do you tell how far to screw in the top 7/16 screw? into the base lock nut? Is it by feel or is there a calibration ?
Most responses I've seen here say to back off the top screw until the engine pings then adjust it inward a bit Need to know the starting point Thanks to any helpful folks on the barn Pete |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:09 PM.