|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-26-2022, 10:07 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,082
|
Need Original intake manifold bolts and washers for 60HP
My source for original nuts and bolts for 60HP sold out, apparently to someone here on the barn. Anyhow, I need a complete set of original bolts and washers for the intake manifold on a 60HP. I know they are being reproduced but I want to stay 100% original if possible. I would venture to say 60 and 85 manifold bolts are the same. Can anyone help me out. My direct email is [email protected]. Thanks. This is on the Early V8 forum as well.
Lawson
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm". Last edited by Lawson Cox; 02-26-2022 at 10:15 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:11 PM.