|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-12-2022, 11:16 PM
|
#12 |
|
Senior Member
Join Date: May 2010
Location: Mn
Posts: 2,543
|
Re: MIG welder experts
Also, cmbrucew touched on this. Use a spring loaded cloths-pin with a piece
of felt or any heavy cloth, and clip it over the wire right before the drive wheel. Get the correct lube from a welding supply place and soak the piece of felt real good. It helps the wire to go threw the liner easier, ask a dealer about it... .
__________________
If mama ain't happy, ain't nobody happy. But if daddy ain't happy...RUN What I GOT DONE TODAY... I got the rear-end put in the recliner, and now I'm going to rest up & watch TV. 
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:06 AM.