Setting Old Rusty's distributor on the Churchill timing. Lathe and Mill required! - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
Setting Old Rusty's distributor on the Churchill timing. Lathe and Mill required!

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

11-05-2021, 08:32 AM	#1
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 9,239	Setting Old Rusty's distributor on the Churchill timing. Lathe and Mill required! One of the most useful tools I have is my Churchill Ford V8 timing fixture. The problem is, the distributor on Old Rusty doesn't fit. In this video I make an adaptor to allow the distributor to sit on the fixture. So sit down and relax. There's some machining, some dicking around setting the timing and a will it start and run at the end. I hope you enjoy it. Mart. https://youtu.be/IrwLNEAHKU8 Last edited by Mart; 11-05-2021 at 03:28 PM.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 04:59 AM.