|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-04-2021, 11:07 AM
|
#1 |
|
Member
Join Date: Nov 2017
Location: NJ
Posts: 61
|
Front end alignment question
I’m in the process of aligning the front end of my 31 CCPU. I’m using a toe in gauge, basically a spring loaded bar that wedges between the tires. After positioning and zeroing the gauge, I pull the truck forward the gauge moves to a toe out reading at the lowest point then moves to a toe in reading at the rear most position. Is that normal?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:37 PM.