|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-23-2020, 09:06 AM
|
#24 |
|
Senior Member
Join Date: Jun 2012
Location: Gaylord, Michigan
Posts: 1,628
 |
Re: 1940 Brake Bleeding
One last question and I promise not to bother you again.....put the drum on and put in that small gasket & washer....screwed the bolt on and if I tighten too tight in order to get the cotter pin in....the wheel is tight to turn the wheel. If I back it off just a touch so I can put in the cotter pin......the wheel turns fine.
Sooooo...question is .....would the nut be too loose by just backing it off a bit ? Thx....Mike |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:23 AM.