KingPin reamer

[GOSFAST]

Originally Posted by Kerk

I prefer to take it to the local Auto machine where they use a Sunnen Hone machine . Lines them up and can be made to fit as desired. JMHO kerk

This is 100% accurate and it's how we've been doing king pin fitting since 1972 and are still do it the same way today, dead-on accuracy to within a few "tenths" if necessary.

You cannot get 100% accurate holes with a conventional reamer, not going to happen?

Thanks, Gary in N.Y.

P.S. Am going to try to keep my posts a bit short, still in the middle of a major health issue, half-way out of the woods. Will try to resume working and moving some parts I've gotten asked about from members here, mainly the bronze-lined guides!