A Fairy tale Crab Build from Bubbas

[BUBBAS IGNITION]

I call this a fairy tale because it went just perfect !!!!! Usually dont felt pretty good today and worked on some past orders .
Crab build..
1- Core bags from Terrys secret stash..
2-should be complete ??? Not 100% but good , only had large timing tag instead of small one, he has a box of both
3-11A weights and spark ring , spray with lube
4-assemble the advance parts with new spacer and snap ring ( thanks third generation)
5 NAPA parts echlin heavy duty , soak point sin the marvel sauna and wipe clean ( helps the fiber blocks )
6-Lube back side of rubbing block to have lasting lube .
7-Use all new stainless socket head screws
8-Install shaft and breaker plate , using large snap ring
9-Use napa fa54 Condesnor ( have had good luck with these almost never failing)
10 lube and install spark brake piston , tighten to three turns
11- run on distributor machine , adjust each side of the points , run for 5-10 minutes at 2000 rpm and recheck for wear ???
12-confirm 11 degrees of spark advance
13 - Install the Bubba sticker ans ship to customer .......

A fairy tale day for sure .

Note , You guys didnt think i could actually quit doing this did ya !!!!