|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-10-2019, 10:00 AM
|
#11 |
|
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Locating dimple on timing gear
Set point opening [ .018-.022"/ preferred .020"]
Locate TDC with timing pin as you did, good. Then use continuity meter or test light to set point opening by loosening and turning rotor. Make sure all shaft back-lash is removed when doing this. It is important to do these procedures in correct order. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:47 AM.