|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-22-2018, 07:48 PM | #1 |
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,120
|
King Pin Reemer
I recently purchased a king pin reamer on eBay, #113067150199 which is NOS KR Wilson. I collect old tools and always wanted one of these. It does appear to be NOS, no rust and mine came factory wrapped in an oil paper. It is marked KRW 1 006, K6. It has a square drive at one end.
My questions are: The cutter is in the middle, how do you accurately support/hold the cutter while reaming a bushing? Is the end of the reamer in a bushing while you are cutting the other bushing? What are you turning the reamer with, a tap holder? What is the procedure to obtain a smooth clean cut? What kind of lubricant is best to use while cutting? Thanks for your help, Ed |
|
|
Sponsored Links (Register now to hide all advertisements) |
|