|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-18-2018, 06:07 PM
|
#1 |
|
Senior Member
Join Date: Jan 2011
Location: Beverly Kansas
Posts: 5,558
|
milling iron heads
i'm getting near the end of a 59a rebuild,and i want to stay with the 59ab heads. i know ol ron likes 50 thou clearance over the piston, and it seems i remember guys are angle milling it off the valve side. i've searched and cannot find my answer, any thoughts welcome
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:14 PM.