|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-19-2017, 12:09 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,120
|
removing broken alemite
I'm trying to remove the broken threaded section of an alemite. It is on the pitman shaft housing of a steering gear and I don't have room between the gear and the engine to tap the easy out to make it bite. It just twists in the hole. Are the alemites too hard for the easy out to bite? Anybody have a trick for this?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:30 AM.