|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-18-2017, 09:05 AM | #17 | |
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,998
|
Re: cam replacement
Quote:
Larry -did you have any problem getting the keepers back on the valves[/QUOTE] Harry, no problem getting keepers back on. If you are using the two piece style I use a little bit of grease to help hold them to the stem while I'm using the valve/spring compressor to release. Just take your time and careful and I'm sure all will go well. Worst case you have to pull something but I think you should be fine. Larry Last edited by larrys40; 03-18-2017 at 09:18 AM. |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|