|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-08-2017, 10:30 PM
|
#1 |
|
Senior Member
Join Date: May 2012
Location: Camarillo, CA
Posts: 288
|
Valve Installation Question
If I am installing new modern stainless valves in a model A block, can I lap in the exhaust valves that are the same size as the originals or do I have to do a complete 3 angle valve job? What about the installation of the bigger 1.700" intake valves? Block has good seat area and do not want to install hard seats.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:33 AM.