Clutch release shaft arm

[Carb Guy]

Broken arm. A while back i said on the Form that I had clutch problems and depressed the clutch and could not shift. pulled the rear end and removed the transmission and bell housing. Did not find anything broke or wrong. Went ahead and ordered a rebuilt clutch pressure plate, new clutch disk, new throw out bearing and pilot bearing. Had the pressure plate and flywheel balanced. put it all back together, and on final assembly my son who did all the work, I just handed him the tools, was under the car and we were hooking up the adjusting arm and trunion to the lever arm, he said the arm is cracked in two, and said this might have been the problem right from the start. Well it is a shame that I did not see this right away if that was the problem. anyway have all new now and shifts just fine, good for another 40 years