|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-03-2016, 05:00 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Stratham, NH
Posts: 272
|
35 Pinion & Drive Shaft Spline Pin
I'm ready to assemble the remainder of my 35 rear end and have a new pin
to secure the pinion and drive shaft splines together. Unlike the original pin, which I removed months ago with its peened over end, the new pin has an approximate 1/4" deep hole drilled into it. What's the intended way to blunt this to prevent it from backing out? Peter |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:07 AM.