|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-02-2016, 07:06 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lancaster, CA
Posts: 917
|
Dangerous Moment Caught on Camera... 55 Ford on Jackstands
today when jacking up the 55 Ford to set it on 4 jackstands so that I could install the Hurst Syncro Loc Shifter (see my thread on the 55 Ford Refresh and Paint). Anyhow, I jacked up the front and put stands under both A-arms. Once I lowered the car onto the stands I tried to push/shake the car from side to side... and no problem - solid.
I went to the back of the car and jacked up the whole rear axle. When putting the car up on 4 stands I like to do each individual A-arm and then go to the rear and jack up the whole axle by going under the differential like this - No problem but I got too confident when I placed the stands under the leaf springs plates and did not check to see how they were oriented. How I caught the problem I do not know but here is the evidence - That's right - the only thing from the 55 contacting the jackstand is that small lip of the nut! I have no idea what would have happened if it would have slid off of there but I don't like thinking about the idea! A word of caution - be careful in the garage...
__________________
Lancaster, California Visit hotrodreverend.com to view hundreds of pictures and videos of the build of the 1955 Ford Club Sedan! |
|
|
Sponsored Links (Register now to hide all advertisements) |
|