|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-22-2010, 01:25 PM
|
#1 |
|
Senior Member
Join Date: Nov 2010
Location: Raynham, Mass.
Posts: 583
|
Upholstery question - 30 Coupe Rumble Area
Hello All,
The upholstery panel on the rear of front seat (as viewed from the rumble seat)does not cover the entire area. A 4" gap was left on the bottom. Is this correct? Also, for the rumble panels on either side of the rumble seat, what type of fastener is required to attach to the slat? Thanks in advance, "No one is smarter than everyone" Last edited by brum1; 11-25-2010 at 08:03 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:59 PM.