|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-05-2015, 12:30 PM
|
#8 |
|
Senior Member
Join Date: Dec 2013
Location: Minnesota, Florida Keys
Posts: 11,629
|
Re: Tea pot carb help
If you use an early 2GC, you'll find that it has to mounted backwards so the linkage etc. ends up on the proper side. I have one on a Canadian aluminum Merc manifold. While the bolt pattern is the same, the throttle bores on the Merc manifold are quite a bit smaller. I bored mine out to match the carb.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:19 AM.