|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-22-2015, 06:48 PM
|
#1 |
|
Member
Join Date: Jun 2010
Location: Perryton
Posts: 69
|
Aluminum Fan Blade Issue
I have placed a new aluminum fan blade on. I have tightened the nut and placed the cotter key in. I ran the engine on a 10 mile test drive. I had to tightened the nut again. I was wondering if I should put a washer behind the nut to put it at the correct alignment for the cotter pin. I would appreciate any help.
Thanks. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:49 AM.