Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-02-2015, 10:12 PM   #1
Graeme / New Zealand
Senior Member
 
Graeme / New Zealand's Avatar
 
Join Date: May 2010
Location: Lower Hutt , New Zealand
Posts: 2,154
Default Trico wiper motors

My NZ 48 carries a RHD version of the 41 US dsh. It has the same arms under the dash as the US 48. The wiper motors for it that came with car in a box of bits is a 41 motor. If using the 41 arms which I don't have it works as it should and the wipers park at the bottom of the windshield ( i had there on my past 46). When I mount this 41 wiper on the 48 mechanism I can't get the wipers to park at the bottom, they park nearly verticle by the centre bar of the shield. I have tried mounting it upside down but the arms on the mechanism foul and don't move. Can anyone please send my a picture of what the wiper motors for a 47 48 look like. I believe there were 2 types. One had a cable to switch it on and the other relied on pure vacuum? I have the 41 switch on my dashboard down at the front of the dash that relies on pure vacuum so I would like to use that if I can.

Does anyone out there have knowledge of the setups for 47/48

thanks
GB
__________________
"you can't make honey out of dog sh*t"

"You're a long time looking at the lid"
Graeme / New Zealand is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:15 AM.