|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-24-2025, 02:02 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,971
|
Rubber Casting repro parts.
Do we have anyone here that has some experience with casting Rubber? I lost my local liaison who was very knowledgeable, and now I need to make some small runs of certain rubber items that are out of production or on 'terminal backorder'.
One is the rubber pieces that clamp windwings. I will likely 3D print molds using the reproduction rubber pieces as samples, but I have a little observational experience at using epoxy to form a mold. If anyone has experience in this, I would like to chat by phone. |
|
|
)
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:19 PM.