Horn rod again

[Russell Reay]

Third time's the charm. Apparently pdf's cannot be attached to these posts, so see the sketch now. The attached photos show the four pieces to be used, but the instructions are seriously lacking in adequate detail. The instructions do not acknowledge the existence of a brass tip already attached to the wire. As I studied the components, I drew the attached sketch and need to know if this is correct. Even if it is, in the lower left corner the instructions say to cut flush after solder. What is to be cut? Should i assume that upon completion the lower terminal cup and lower brass cup are in constant electrical contact ? It would appear that the purpose of the horn button is to short the upper brass contact to the horn rod. Is that correct?