|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: SW WI
Posts: 359
|
![]()
I'm trying to determine the exact locations for the hoood bumpers. I've got a Carpenter bumper kit with 8 small bumpers I figure go along the sides equally spaced but I'm not sure where the 2 bigger ones go or the 2 big flat ones go. Anyone with pictures or can describe where they go?
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Oct 2010
Location: Orem, Utah
Posts: 5,762
|
![]()
Measuring from the back of the bottom edge of the hood the 8 small bumpers are at 6", 21", 38", and 41" on each side. (Should be a hole in the bottom edge of the hood at about each of those locations to insert the bumper.) The two big bumpers go on each side of the spring/latch post as in this picture:
![]() The two big flat ones don't go on the 41-48. They are for the 39-40.
__________________
Prof. Henry (The Roaming Gnome) ![]() "It is good to have an end to journey toward; but it is the journey that matters, in the end.” *Ursula K. Le Guin in The Left Hand of Darkness Last edited by Old Henry; 12-05-2012 at 10:39 PM. |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: SW WI
Posts: 359
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|