10-23-2017, 10:57 AM
|
#1 |
|
Senior Member
Join Date: Nov 2010
Location: Sebastian, FL
Posts: 483
|
Ujoint
I just rebuild my original Ujoint and it came out beautiful. Have not put it in yet but now hesitant. Something I was looking at over the weekend mentioned balancing a Ujoint. I had not heard of balancing the joint and now thinking of the driveshaft as well. Any ideas or helpful hints while I have everything apart? Looking forward to getting it back together and going for a drive but NOT looking forward to taking it apart again for a while....lol. Thanks, Jim
|
|
|
|
10-23-2017, 11:18 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Ujoint
Nope, not an issue. Forget it
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
10-23-2017, 11:44 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 1,462
|
Re: Ujoint
Did you assemble the two halves of the U-joint in the same orientation as it was before? That should assure balance.
|
|
|
|
|
10-23-2017, 09:54 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Ujoint
I wouldn't worry about it. Just be sure it has lots of grease. I pack them full.
|
|
|
|
|
10-23-2017, 09:58 PM
|
#5 |
|
Senior Member
Join Date: Mar 2017
Location: southern California
Posts: 725
|
Re: Ujoint
Sponsored Links (Register now to hide all advertisements)
__________________
"That's my wild unsubstantiated guess, and I'm sticking to it regardless of the facts!" |
|
|
|
 |
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:07 PM.