|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
|
04-08-2023, 11:28 AM | #1 |
Member
Join Date: Feb 2022
Posts: 54
|
36 ford flathead rear main seal?
My mechanic is asking what is used for the rear main seal . It doesnt look like there is a place for one. Not even a rope seal.
|
04-08-2023, 11:41 AM | #2 |
Senior Member
Join Date: May 2015
Posts: 8,649
|
Re: 36 ford flathead rear main seal?
No rear main seal in an original '36 flathead engine. They use what is called a "slinger"...
Ford Part # 40-6310...
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 Last edited by petehoovie; 04-08-2023 at 11:50 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
04-08-2023, 01:01 PM | #3 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,841
|
Re: 36 ford flathead rear main seal?
The upper part in the block is 18-6335. https://reds-vintage-parts.com/store...t-18-6335-used
|
04-08-2023, 02:21 PM | #4 | |
Senior Member
Join Date: May 2015
Posts: 8,649
|
Re: 36 ford flathead rear main seal?
Quote:
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
|
04-08-2023, 02:21 PM | #5 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,860
|
Re: 36 ford flathead rear main seal?
Petes photo is of the front slinger, goes at front of crankshaft between timing gear and front pulley...
The 18-6335 was superseded with 78-6335 which will work better with your 'double slinger crankshaft.
__________________
Unfortunately, two half wits don't make a whole wit! |
04-08-2023, 05:07 PM | #6 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,860
|
Re: 36 ford flathead rear main seal?
Sponsored Links (Register now to hide all advertisements)
Yes...superseded with 78-6335 as I posted above. Actually, either the 18 prefix or the 78 prefix can be used, but the 78 prefix gives better control.
__________________
Unfortunately, two half wits don't make a whole wit! |
04-09-2023, 09:37 AM | #7 |
Senior Member
Join Date: May 2010
Location: Green Bay
Posts: 391
|
Re: 36 ford flathead rear main seal?
Here is what I did on my 35LB rear seal.
Check link out from 2010 https://www.fordbarn.com/forum/showthread.php?t=21404 |
|
|
Sponsored Links (Register now to hide all advertisements) |
|