|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-08-2013, 07:40 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Sugar Land, TX
Posts: 4,420
|
rod cap nuts in 37 21 stud motor
The rod nuts I took off on #1 cylinder today were very tight. I had to use my impact wrench to get them off. Lock tight perhaps? Can I re-use the nuts or should I get new ones?
The pistons are standard. Can I likely get the rings locally or do I have to get them from Macs? Last edited by mrtexas; 03-09-2013 at 09:19 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:09 PM.