|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-19-2024, 01:06 AM
|
#1 |
|
Member
Join Date: Jun 2011
Location: Sydney - Australia
Posts: 89
|
Flywheel housing
Hi guys, I have read up on previous posts Regarding Fitting Flywheel Housing to Motor. - I have a B Pressurised motor which was leaking at the rear Camshaft.
Question -Is it best to fit the supplied Thin Gasket and use some Permatex. Or - Just use some RTV Sealant around the Camshaft Hole. What are peoples thoughts on this. Thankyou |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:00 PM.