The Ford Barn

redmodelt · 07-16-2025, 10:23 AM

I don't have one handy so could someone give me the diameter and length of the machined area where it goes into the head, also, the diameter of the shaft.
Thanks.
This is for a Model T project and need to see if it will work for my application.

BRENT in 10-uh-C · 07-16-2025, 12:35 PM

Quote:

Originally Posted by redmodelt

I don't have one handy so could someone give me the diameter and length of the machined area where it goes into the head, also, the diameter of the shaft.
Thanks.
This is for a Model T project and need to see if it will work for my application.

Mark, the housing is 0.995" in diameter and roughly 1.250 in length. The shaft should be 0.500".

redmodelt · 07-17-2025, 09:08 AM

Sponsored Links (Register now to hide all advertisements)

Brent in 10-uh-C thank you very much, that will help.

07-16-2025, 10:23 AM	#1
redmodelt Senior Member Join Date: May 2010 Location: Portland OR Posts: 6,410	Distributor questions I don't have one handy so could someone give me the diameter and length of the machined area where it goes into the head, also, the diameter of the shaft. Thanks. This is for a Model T project and need to see if it will work for my application. __________________ I know the voices aren't real but damn they have some good ideas!

07-17-2025, 09:08 AM	#3
redmodelt Senior Member Join Date: May 2010 Location: Portland OR Posts: 6,410	Re: Distributor questions Sponsored Links (Register now to hide all advertisements) Brent in 10-uh-C thank you very much, that will help. __________________ I know the voices aren't real but damn they have some good ideas!