|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
09-10-2024, 05:28 PM
|
#1 |
|
Senior Member
Join Date: Sep 2013
Location: Canyon Country, Ca
Posts: 158
|
Borg Warner R10 OD Removal
Hi All,
I will be removing my Borg Warner R10 OD to install a Mitchell OD and had a few questions since I did not do this installation. Do I just need to disconnect the radius rods and then remove the torque tube bolts from the rearend? Then slide the Borg Warner OD off and I am left with a short stub driveshaft similar to the Mitchell OD? Thanks, Denny |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:59 PM.